四角空心锥阻浪块模具采用钢板加工制作，外部焊接数条筋板作为支撑，筋板的作用是为了保证模具的严密性，模具不易不漏浆的现象发生，模具采用的筋板较厚，因为浇筑混凝土的压力长期会对模具冲击，筋板的尺寸后能够承受混凝土的压力，主体部分钢板厚度在4mm左右，四角空心锥阻浪块模具属于空心的模式但是生产出的预制件是实心的模式，每块四角锥成品重量可达到上千斤左右。在制作四角空心锥阻浪块时，需要使用专业的生产设备和技术。首先需要准备好预制的混凝土材料，然后将模具放在制作平台上，将混凝土倒入模具中。在进行浇筑之前，还需在模具内表面均匀涂抹模具释模剂，以防止混凝土黏附在模具上，便于脱模，然后通常还会在模具内部放置钢筋骨架以进一步提升混凝土构建的坚硬程度，接下来就可以将事先搅拌好的混凝土倒入模具中，在倾倒时要随时观察模具的密封状况，出现细缝漏浆要及时填补，以免造成混凝土的浪费以及产品的不规整，通常这种大型模具还要进行振动，以保障混凝土均匀填充。Beforepouring, it is also necessary to evenly apply the mold releaseagent on the inner surface of the mold to prevent the concrete fromsticking to the mold, which is convenient for demoulding, and thenusually place the steel skeleton inside the mold to further enhancethe hardness of the concrete construction, and then the concretethat has been stirred in advance can be poured into the mold, andthe sealing condition of the mold should be observed at any timewhen pouring, and the fine slurry leakage should be filled in time,so as not to cause the waste of concrete and the irregularity ofthe product, usually this large mold also vibrates to ensure thatthe concrete is evenly filled。
